USING TEMPORARY BRIDGES  -2-
 
 

I solder the upper end of the bridge on the surface of the lamp.
 

Here is the lower end of the bridge soldered aswell. As you can see, it is not in absolute upright  position,

but as the copper wire is a little bit smaller than the whole of the connector, there is a little bit of "tolerance".
 

After I soldered 3  bridges on my lamp, it is time to get it off the mold.

I opened the fixing  screws and switched on the three 100 W  lights  I had assembled inside the mold,

before waxing it